bg
Info centre > Pharmaceuticals
Optive Fusion™ UD

Allergan Optive Fusion™ UD

Allergan OPTIVE FUSION™ UD is a dual-polymer synergy uniquely formulated to provide comfortable protection to maintain a healthy tear film and relieve aqueous-deficient dry eye.
The two most sought-after polymers in eye care can now be found in one powerfully soothing single-drop formula. Only OPTIVE FUSION™ UD combines the properties of Carboxymethylcellulose (CMC) and Hyaluronic Acid (HA) to lubricate, protect, and restore a healthy tear film for relief of aqueous-deficient dry eye.
OPTIVE FUSION™ UD is fully compatible with contact lenses and is for single-use application only. Use vial once and discard.

Innovative technology

Introducing innovative technology by combining HA, CMC, and Osmoprotectants into one drop.1-5
Comfort with less blur
Ocular surface hydration
Restores tear film integrity
Protection of the ocular surface
Osmoprotection of the epithelial cells

OPTIVE FUSION™ delivers relief of the symptoms of DED (dry eye disease) by its power of 3:1

Hyaluronic Acid (HA) based tears: 2,3

Soothes the symptoms of DED
Enhances water retention

Carboxymethylcellulose (CMC) Based Tears: 2-3

Stabilises the tear film by providing comfort and lubrication
Improves ocular surface integrity
Long retention time

Osmoprotection Based Tears: 3,5

Helps protect the surface of your eyes by providing hydration
Protects against hyperosmotic stress
Restores osmotic balance

Instillation

Place one or two drops of OPTIVE FUSION™ UD in the affected eye(s) as needed.

Step 1

Tilt your head back, look upwards, and gently pull down your lower eyelid to create a small gap.

Step 2

Hold the unit dose vial upside down and allow each drop to fall into the eye
Avoid touching the surface of the eyeball or the eyelids with the applicator tip
Use one or two drops per eye as needed

Step 3

Close the eye for two or three seconds to help spread OPTIVE PLUS™ UD evenly over the surface of the eye.

Ingredients

OPTIVE FUSION™ UD is supplied in foil wrapped pouches. Each vial contains 0,4 ml of solution.

Each ml contains:

Sodium hyaluronate 0.1%
Sodium carboxymethylcellulose 0,5 %
Glycerine 0,9 %
PRESERVATIVE-FREE

Precautions

  • - Do not use if allergic to any of the ingredients
  • - Do not swallow solution
  • - To avoid contamination or possible eye injury, do not touch vial tip on any surface, and avoid direct contact with the eye
  • - Do not use after expiry date marked on the product
  • - Keep out of the reach of children
  • - Store at room temperature
  • - Allow 5 minutes between the administrations of ophthalmic product
  • - Do not use the unit dose vial or product packaging if damaged
  • - Do not use if solution changes colour
  • - Keep away from sunlight
  • - Use vial once and discard

Add-on treatment

Higher-viscosity OPTIVE® GEL DROPS are an effective add-on treatment to OPTIVE PLUS™ , providing long-lasting relief both during the day and at night.

Find out more about OPTIVE® GEL DROPS

OPTIVE FUSION™ Eye Drops and OPTIVE FUSION™ Unit Dose Eye Drops: Contains sodium hyaluronate 1 mg/ml, carboxymethylcellulose sodium 5 mg/ml, and glycerine 9 mg/ml.
OPTIVE® Gel Drops: Contains carboxymethylcellulose sodium 10 mg/ml and glycerine 9 mg/ml.
For full prescribing information, refer to the Instructions for Use.
Allergan Pharmaceuticals (Pty) Ltd, PO Box 6024, Halfway House, 1685, South Africa (Co. Reg. no. 1984/005576/07)
Telephone: +27 (0) 11 545 6600, Facsimile: +27 (0) 11 315 6008
www.allergan.co.za
© 2018. ®/™ Registered Trademark/Trademark of Allergan, Inc. ZA/0104/2018

Clinical References

1. Allergan OPTIVE FUSION™ labelling, 2017. App: Section 5. 1. Jones L et al. Ocul Surf 2017, 15: 575-628

2. Simmons P et al. Clin Ophthalmol. 2015 ;15(9) : 665–675

3. TFOS DEWS II management and therapy report. The Ocular Surface. 2017;15(3): 575–628

4. Sanchez MA et al. Cornea. 2010;29(2): 167–171

5. Baudouin C et al. Ocul Surg. 2013;11: 246–248